Permaculture Wizard

Permaculture Wizard›Blog›Water

Walk your land in the rain: where the water really goes

TL;DRJoey on the cheapest site survey there is: walk your land in autumn rain, then measure your roof runoff and soil drainage before you dig a pond.

It rained for three days straight last week, and I spent most of it outside in a jacket that stopped being waterproof in 2019. Not because I enjoy it. A proper autumn rain is the cheapest site survey you will ever get, and most people watch it through the kitchen window.

Here is the short version: before you dig a pond, a swale or even a vegetable bed, go out during heavy rain and watch where the water goes. Then measure two things: how much water arrives and how fast your soil takes it. The rest is how.

Why is an autumn rain the best site survey you'll get?

In October and November the leaves are coming down, the plants are drinking less, and the soil is filling up. Water that soaked away quietly in July now runs, pools and shows you its paths. You see the land the way it behaves when it is full, and that is the condition your design has to survive.

Maps help, but only so far. Our own site check gives you the monthly rain and the slope across your plot, and it says plainly that the slope comes from a terrain model of roughly 90 metres. That is good enough to tell a hillside from a valley floor. It is not good enough to see the dip behind your shed where the water sits for two days. Only your boots can find that.

What should you look for on a rain walk?

Go out when it is really raining, not drizzling, and again an hour after it stops. Walk the boundary first, then cross the middle, and mark these on a rough sketch:

Then come back on a dry day and look at what grows where you saw water. Plants keep a longer record than you do. German gardening references list creeping buttercup, field horsetail, silverweed and coltsfoot as signs of wet, compacted soil or waterlogging, and rushes and sedges as signs of ground that is wet all the time or swings between wet and dry (Der Bio-Gärtner, Vitipendium). One buttercup means nothing. A carpet of them along the bottom of your slope means the sketch you just made is right.

A warning from experience: do not dig or walk heavily on that ground while it is soaked. Working wet soil smears and seals it, which is exactly the problem you are trying to find. Iowa State's extension service even warns that digging in overly wet soil can glaze the sides of a test hole and give you false results (Iowa State Yard and Garden).

How much water is coming off your roof?

This is the one calculation everybody should do, and it takes ten seconds. One millimetre of rain on one square metre is exactly one litre. So a roof with a footprint of 100 m² in a 20 mm rain sheds 2,000 litres. Use the footprint seen from above, not the sloped roof surface, and expect a hard roof to deliver about 75 to 90 percent of that to the gutter after splash and evaporation (Helpful Calculator's explanation).

Now look at the 300-litre barrel under your downpipe. It was full after about three millimetres of rain, and the other 1,700 litres went next to your foundations or into the sewer.

I am not telling you to buy a bigger tank. I am telling you to know the number, because it decides how big a pond, rain garden or swale must be, or where its overflow goes.

How fast does your soil soak it up?

Now the second number. Do a simple infiltration test, the kind extension services recommend for rain gardens:

  1. Dig a hole about 30 cm deep and the width of a spade, in the spot you are thinking of using.
  2. Roughen the sides, fill it with water and let it drain completely. This wets the soil around it.
  3. Fill it again, put a ruler in, and note the level. After 15 minutes, measure the drop and multiply by four. That is your rate per hour.

Iowa State says soils that drain about 25 to 75 mm an hour (1 to 3 inches) suit most plants, and anything under 25 mm an hour is poorly drained (Iowa State Yard and Garden). For a rain garden, New Hampshire's environment department asks for at least about 13 mm an hour (half an inch), and says that if water is still standing after 24 hours, or the hole fills by itself, you should pick another place (NH DES infiltration test).

Do it in three or four spots; they will differ more than you expect. Cover the hole between readings. A child or a hedgehog in a water-filled hole is not the kind of observation we want.

Where does a pond or swale go, and do you need a permit?

Put the two numbers on your sketch next to the arrows and puddles, and the design starts to suggest itself. Slow soil where water already pools is a natural pond or wet meadow, not a place for fruit trees. Fast soil on a gentle slope can take a swale on contour that spreads roof water out instead of dumping it. And whatever you build, plan the overflow first. Iowa State puts it bluntly: don't just redirect the water to someone else's yard. I agree. Your neighbour will remember.

On permits, there is no single answer, and anyone who gives you one is guessing. In Switzerland the canton and municipality decide. Canton Bern's building permit decree lists ponds among small garden installations that generally need no permit (Bern BewD), while in Canton Aargau a building-zone pond is permit-free only up to about 10 m², according to the municipality of Gränichen's guide (Gränichen building guide). Meanwhile a Swiss wildlife brochure suggests a natural pond of at least about 15 m² and 50 cm depth to find its own ecological balance (infofauna pond brochure). Notice that the good pond is bigger than the free pond. That is not a reason to skip the pond. It is a reason to phone your municipality before you rent the digger, and the same goes for Germany and Austria, where the rules also differ by state.

FAQ

What if it doesn't rain properly before winter?

Run a hose on a dry day to imitate a downpipe and watch where the water goes. It's not a real storm, but it shows the first paths. Do the full rain walk when the next front comes through.

Is one test hole enough?

No. Soil changes over a few metres, especially near old building work and filled ground. Test every spot where you plan to put water, and note the date and weather, because a test after a week of rain gives slower numbers than one in a dry spell.

Can I put a pond where the puddles already are?

Often that is the best place, because the water already goes there. But check what is under it first. A puddle over a buried pipe, a septic line or a foundation is a warning, not an invitation. Ask your municipality about permits and plan where the pond overflows during the biggest rain you can imagine.

If you want the rain, slope and frost numbers for your own plot before you go out with your notebook, check your land at https://permawiz.com/site-check/.

pondsrainsite readingsoil drainagewater

What does your land say?
Drop a pin and get your climate, frost dates, hardiness zone, sun and slope in seconds — then a permaculture design draft for your spot.
Check my land — free